To reduce false signals when searching in a very trashy ground, scan only a
small area at a time using slow, short overlapping sweeps.
Keep the search coil moving at a comfortable rate. If you walk too fast, you
can’t overlap your s sweeps and yo u will miss a lot of ground. Also if yo u sweep
too fast, you will lose sensitivity and miss the deep targets
6. Using a headphone
You should always use a headphone whenever you search with your metal
detector. Headphone is especially useful in noisy area, such us the beach and
rear city area. It enhances audio perception by bringing the sound directly to
yo ur to your ears while masking ―outside‖ noise int erferences. You shell be
amazed at how much better you can hear the detector signals with the
headphone than you can with the speaker alone. Using head phones also save
battery power.
To connect a headphone to the detector, insert the headphone jack into the
―Phones‖ on the bottom side of the box.
NOTE: The detector internal speaker will be disconnected when you
connect a headphone.
7. Charging storage batteries and indications for their status.
If a light ― Low battery‖ appears while using the detector that means you
have to stop using it and recharge the batteries as follows: put the jack of the
charge device into ―CHARGE‖ nest and place the device into electric net of
220V.
The charging is automatic and begins when the device is SWITCHED
OFF and you plug the charger into the charging jack of the back panel of the
device. The jack cage is ―-‖ and the middle terminal is ― +‖.
Charging dependin g on the level of discharge of the batteries. It’s not nece ssary
to keep eyes on charge device, because it is supplied with automatic turn off
and batteries couldn’t be damaged no ma tter how long the y will sta y in the
charge device. The charging continues till the moment when the batteries reach
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales